I am seeing quite a few sensors reporting -307C temperature today. What might cause this non-sensical value?
3 Likes
@Ian_Brogden could you provide a screenshot and map link where you see this?
1 Like
Hi @Josh_PurpleAir
I have the same issue with the map in general, not just on my sensors.
Here is a screenshot of the -307 degree issue.
To replicate it you need to open the map to any data layer that is not Estimated Temperature, then scroll the map until the sensors that were displayed are off the screen, then change to the Estimated Temperature data layer, scroll back to the first displayed sensors and -307 degrees should show up. It usually fixes itself, but sometimes it locks as -307 degrees and you have to reset the map to fix it.
I also ran into this issue today as well.
When attempting to change data layer after leaving the screen on a single spot for ~2 minutes the map markers go weird.
I was on Relative Humidity for about 2 minutes and tried to change to US EPA PM2.5 AQI with US EPA conversion and got this instead.
Thank you 
1 Like